Home CCTV Perth
Security camera mounted on timber fascia beside a limestone wall on a Fremantle home

Areas we cover

CCTV Installation Fremantle

Limestone, heritage and salt air, often all on the same job. Each one changes where a camera can go.

  • A street of heritage limestone and weatherboard cottages with corrugated roofs
  • A rough limestone garden wall in front of an old cottage
  • A narrow side street of terrace housing with a glimpse of the port beyond

Get a Free Quote in Fremantle

Tell us where you are and what you need. We inspect the property, then put the quote in writing before any work begins.

Tell us about the property, where you would like cameras, and anything already installed.

Quick check

Loading quick check…

We use your details only to prepare your quote.

Local notes

What Matters in Fremantle

The things about Fremantle that change where a camera goes, or how the cable gets to it.

Limestone is unforgiving
A fixing into stone is hard to make good if you ever move the camera, and on an older wall it can do damage you cannot undo.
Timber and modern additions instead
Fascia, a soffit or a rear addition is nearly always the better answer than the stonework.
Heritage rarely stops a camera
It is not usually a permanent structural change. What it can affect is the street facing elevation, so tell us before we quote rather than after.
Sheltered position first
As anywhere on the coast, the camera goes in the most sheltered spot that still gives the view.
Seal the entry, choose the fixings
The cable entry behind the bracket gets sealed properly, and fixings are chosen so a bolt does not seize into place.
A wipe down twice a year
Housings this close to the water are worth checking a couple of times a year. It is a small job that prevents a bigger one.

What changes the job

What Changes the Job at Your Address

What is already in the walls matters most. These homes have often been rewired more than once, so we check before planning anything new.

How many levels
A single storey runs through one roof space. A second storey means the ground floor cameras take a wall cavity or a short hidden run outside.
What the roof is
Tile lifts and gives us a way in. A low pitch steel roof leaves very little crawl space, so the route has to change.
Where the recorder can live
It needs power, somewhere out of the heat and a path back to the router. Usually that is the garage, a cupboard or the roof space.
Whether there is cable already
An older system can leave usable cable in the walls. We test it rather than assume it, and reuse whatever passes.

Before we drill

Strata, Rentals and Shared Walls

Strata and rentals are both common, so we sort the sign off before anything comes on site.

Strata and common property
Anything fixed to a shared wall, a common roof or a lobby goes to the owners corporation first. We put the request in writing so you have something to hand over.
Renting the place
We ask for the owner's permission before anything is drilled. Where that is not on, we will show you what can go up without fixings.
Shared walls and boundaries
We aim the camera at your property, show you the frame before it is fixed, and move it if it takes in more of next door than it needs to.

Common Questions in Fremantle

A small white camera mounted under a painted timber eave above rough limestone blockwork on a Fremantle cottage
Can you mount a camera on a limestone wall?

We would rather not, and usually we do not have to. Limestone is thick, irregular and hard to make good if the camera ever moves, and on an original wall a fixing can do damage that cannot be undone.

Timber fascia, a soffit, a barge board or a modern rear addition almost always gives us the same angle. If stone really is the only option we will talk it through with you first.

My house is heritage listed. Can I still have cameras?

In most cases yes, because a camera is not usually treated as a permanent structural change. What can be restricted is what goes on the street facing elevation, so it is worth telling us about the listing when you first call.

The positions then get planned around it from the start, and we keep the street facing cameras small and set back so they are barely noticeable.

Does being this close to the water change the install?

It changes the details rather than the system. Cameras go in the most sheltered spot that still gives the view, the cable entry behind the bracket is sealed properly, and the fixings are chosen so they will not seize with corrosion.

That is what stops a camera swap in a few years turning into a much bigger job. Wiping the housings down occasionally helps as well.

If not the stone, where do the cameras actually end up?

Timber fascia, a soffit, or a modern rear addition. Those three cover between them almost everything people want watched.

They cover the same view far more often than expected, and none of them leave a mark you cannot make good.

How often do coastal housings need looking at?

A couple of times a year is plenty. A wipe down and a look over the seals and fixings.

It is a small job that stops a seized bolt or a perished gland turning into a replacement camera.

What actually kills a camera this close to the water?

Moisture sitting in the cable entry behind the bracket, and fixings that seize into place.

Neither is dramatic and both are dealt with at install. That is the difference between a camera that lasts and one that does not.

(08) 6275 6546Get a free quote